This DTC is output when an open circuit in the A.D.D. shift motor drive circuit is detected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P17A0 | Automatic Disconnecting Differential Motor Control Circuit Open | ·
Diagnosis Condition: While switching between H2 and H4 (A.D.D. shift motor operating) with the ignition switch turned to ON ·
Malfunction Status: Open circuit in the A.D.D. shift motor drive circuit ·
Malfunction Time: 0.03 seconds or more ·
Other: 1 trip detection logic |
·
Wire harness and connector ·
4 wheel drive control ECU ·
A.D.D. actuator (differential motor actuator assembly) |
Refer to DTC P17A9.
Click hereDrivetrain>VF2CM TRANSFER / 4WD / AWD>TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM>P17A9
Disconnect the C61 4 wheel drive control ECU connector.
Disconnect the C57 A.D.D. actuator (differential motor actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C61-2 (DM1) - C57-1 (DM1) | Always | Below 1 Ω |
| C61-6 (DM2) - C57-2 (DM2) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(A.D.D. Actuator (Differential Motor Actuator Assembly)) |
Disconnect the C57 A.D.D. actuator (differential motor actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (DM1) - 2 (DM2) | Always | 1.5 to 10 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG