Home › Drivetrain › VF2CM TRANSFER / 4WD / AWD › 4WD CONTROL ECU › 2015.08–2016.01
RM3270E _52 Drivetrain _041684 VF2CM TRANSFER / 4WD / AWD _0217838 4WD CONTROL ECU A

VF2CM TRANSFER / 4WD / AWD  4WD CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the 4 wheel drive control ECU removal /installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of ECM
·

Learning values save

·

Learning values write

·

Vehicle Identification Number (VIN) registration


·

Engine starting

·

DTC P0630 is output


(Click here)
for RC61F:

Performing iMT installation information reset


·

iMT system

·

DTCs are output


(Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.

PROCEDURE

Hide 89533 2.REMOVE 4 WHEEL DRIVE CONTROL ECU

a.
C315959

Remove the nut and 4 wheel drive control ECU.