Home › Drivetrain › VF2CM TRANSFER / 4WD / AWD › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM
RM3270E _52 Drivetrain _041684 VF2CM TRANSFER / 4WD / AWD _0201040 TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM C

VF2CM TRANSFER / 4WD / AWD  TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM  P17A8  Transfer Shift Motor Control Circuit Circuit Open  


DESCRIPTION

This DTC is output when an open circuit in the transfer shift motor drive circuit is detected.

DTC No. Detection Item DTC Detection Condition Trouble Area
P17A8 Transfer Shift Motor Control Circuit Circuit Open
·

Diagnosis Condition: While switching between H2 and H4 or while switching between H4 and L4 (transfer shift motor operating) with the ignition switch turned to ON

·

Malfunction Status: Open circuit in the transfer shift motor drive circuit

·

Malfunction Time: 0.03 seconds or more

·

Other: 1 trip detection logic


·

Wire harness and connector

·

4 wheel drive control ECU

·

Transfer shift actuator assembly



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - TRANSFER SHIFT ACTUATOR ASSEMBLY)
a.

Disconnect the C61 4 wheel drive control ECU connector.


b.

Disconnect the C74 transfer shift actuator assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C61-8 (TM1) - C74-2 (TM1) Always Below 1 Ω
C61-7 (TM2) - C74-1 (TM2) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

2.INSPECT TRANSFER SHIFT ACTUATOR ASSEMBLY (TRANSFER SHIFT MOTOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT TRANSFER SHIFT ACTUATOR ASSEMBLY (TRANSFER SHIFT MOTOR)
a.

Disconnect the C74 transfer shift actuator assembly connector.


b.
C325774C02
1.854,0.75 2.104,1.563 false 2.802,0.938 2.385,1.594 false 0.198,0.271 0.51,0.469 0.313,0.198 10 false *a 1.719,0.563 2.177,0.76 0.458,0.198 10 false TM1 2.719,0.76 3.031,0.958 0.313,0.198 10 false TM2
*a Component without harness connected
(Transfer Shift Actuator Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (TM1) - 1 (TM2) Always 1.5 to 10 Ω



Result:
Proceed to
OK
NG



OK

REPLACE 4 WHEEL DRIVE CONTROL ECU

NG

REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY