While depressing the clutch pedal, the clutch start switch assembly sends a signal to terminal MTN of the 4 wheel drive control ECU. While the signal is input, switching between H4 and L4 is possible.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the GTS on.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Four Wheel Drive / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Clutch SW | Clutch start switch status | ON or OFF | ON: Clutch pedal depressed
OFF: Clutch pedal released |
Used only for vehicles with a manual transmission.
Displays OFF for vehicles with an automatic transmission. |
| Tester Display |
|---|
| Clutch SW |
The display changes according to the clutch pedal operation.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereDrivetrain>VF2CM TRANSFER / 4WD / AWD>TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Check that the ECD system operates normally.
Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>HOW TO PROCEED WITH TROUBLESHOOTING
ECD system operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>HOW TO PROCEED WITH TROUBLESHOOTING
Disconnect the C60 4 wheel drive control ECU connector.
Disconnect the B2 clutch start switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C60-18 (MTN) - B2-2 | Always | Below 1 Ω |
| C60-18 (MTN) or B2-2 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG