Home › Engine / Hybrid System › 1GD-FTV ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › 2015.08–2016.01
RM3270E _51 Engine / Hybrid System _041672 1GD-FTV ENGINE MECHANICAL _0205127 REAR CRANKSHAFT OIL SEAL A

1GD-FTV ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear crankshaft oil seal removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of ECM
·

Learning values save

·

Learning values write


Engine starting (Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.
Replacement of engine assembly
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting (Click here)
Clear Crank Time Compensation Data Engine starting (Click here)
for AC60F:

Replacement of automatic transmission assembly


Reset memory
·

Large shift shock

·

Engine overruns


(Click here)
for AC60F:

Replacement of automatic transmission fluid


ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
for 4WD:

Front wheel alignment adjustment


·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


VSC malfunctioning (Click here)

PROCEDURE

Hide 33030 1.REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)

Hide 35000 2.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

Hide 31210 3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

Hide 31250 4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 13405 5.REMOVE FLYWHEEL SUB-ASSEMBLY

Hide 11381A 7.REMOVE REAR ENGINE OIL SEAL

a.
A340242C01
1.885,1.344 1.885,1.594 false 1.833,0.969 2.333,0.5 2.333,0.5 2.5,0.5 true 2.521,0.375 2.75,0.563 0.229,0.188 10 true *a 1.844,1.625 2.156,1.781 0.313,0.156 10 false *b 1.156,1.635 1.469,1.792 0.313,0.156 10 false *c
*a Protective Tape
*b Cloth
*c Cut


Using a knife, cut off the lip of the rear engine oil seal.


b.

Using a cloth and screwdriver, pry out the rear engine oil seal from the rear engine oil seal retainer.

NOTICE:

Be careful not to damage the crankshaft and rear engine oil seal retainer.


HINT:
·

After removal, check the crankshaft for damage. If damaged, smooth the surface with #400 sandpaper.

·

Tape the screwdriver tip before use.