The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the door control receiver removal/installation are shown below.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55302A
3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
89740A
4.REMOVE SMART DOOR CONTROL RECEIVER ASSEMBLY (w/ Smart Entry and Start System)
|
Nut |
|
Connector |
Remove the nut.
Detach the guide and remove the smart door control receiver assembly.
Disconnect the connector.
89741
5.REMOVE DOOR CONTROL RECEIVER (w/o Smart Entry and Start System)
|
Nut |
|
Connector |
Remove the nut.
Detach the guide and remove the door control receiver.
Disconnect the connector.