The illuminated entry system controls the engine switch illumination.
Before replacing the certification ECU (smart key ECU assembly), refer to the Service Bulletin.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Entry&Start / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Power/Engine SW Light | Engine switch illumination | OFF or ON | w/ Smart Entry and Start System |
| Tester Display |
|---|
| Power/Engine SW Light |
Engine switch illumination comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the engine switch (engine switch illumination).
Click hereEngine / Hybrid System>1GD-FTV STARTING>ENGINE SWITCH>REMOVAL
Inspect the engine switch (engine switch illumination).
Click hereEngine / Hybrid System>1GD-FTV STARTING>ENGINE SWITCH>INSPECTION
Engine switch illumination is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G45 engine switch (engine switch illumination) connector.
Disconnect the G16 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G45-9 (SWIL) - G16-19 (SWIL) | Always | Below 1 Ω |
| G45-6 (AGND) - G16-24 (AGND) | Always | Below 1 Ω |
| G45-9 (SWIL) or G16-19 (SWIL) - Body ground | Always | 10 kΩ or higher |
| G45-6 (AGND) or G16-24 (AGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG