When replacing the body ECU, be sure to initialize the automatic light control system.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
As the door control battery is installed between the vehicle battery and body ECU, first perform the inspections to confirm that there are no malfunctions in the power source circuit for the body ECU before performing this troubleshooting procedure.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PRECAUTION
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses, relays and bulbs related to this system before inspecting the suspected areas below.
*1: w/ Smart Entry and Start System
*2: w/o Smart Entry and Start System
| Symptom | Suspected Area | Link |
|---|---|---|
| Glove box light assembly does not illuminate. | Glove box light assembly | - |
| Harness or connector | - |
| Symptom | Suspected Area | Link |
|---|---|---|
| Vanity light assembly does not illuminate. | Vanity light bulb |
|
| Visor assembly |
|
|
| Harness or connector | - |
| Symptom | Suspected Area | Link |
|---|---|---|
| No instrument panel illumination comes on | Headlight dimmer switch assembly |
|
| Harness or connector | - |