When the theft deterrent system is switched from the armed state to the alarm sounding state, the body ECU transmits a signal to cause the horn to sound at intervals of 0.4 seconds.
Inspect the fuses for circuits related to this system before performing the following procedure.
If the body ECU has been replaced, it is necessary to initialize the body ECU.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
Press the horn switch and check if the horn sounds.
| Result | Proceed to |
|---|---|
| Horn sounds | A |
| Horn does not sound | B |
A
B
Remove the body ECU.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL
Disconnect the instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2D-14 - A-9 (HORN) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG