Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH › 2015.08–2016.01
RM3270E _59 Vehicle Exterior _041719 WIPER / WASHER _0213518 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  INSTALLATION  


PROCEDURE

Hide 84650 1.INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY

a.
B407652C01
0,0 0,0 false
V113147

Install in this Direction


Attach the claw to install the windshield wiper switch assembly.


b.
B407650

Connect the 2 connectors.


Hide 45286B 2.INSTALL UPPER STEERING COLUMN COVER

a.
B407653C01
0,0 0,0 false
V113147

Install in this Direction


Attach the claw to install the upper steering column cover to the steering column assembly.


Hide 45287 3.INSTALL LOWER STEERING COLUMN COVER

NOTICE:

Make sure to correctly follow the installation procedures. Otherwise, the part may become damaged.


a.
B427705C01
0.125,0.063 0.438,0.219 0.313,0.156 10 false *A 0.135,2.51 0.448,2.667 0.313,0.156 10 false *B
*A w/ Entry and Start System
*B w/o Entry and Start System
V113147

Install in this Direction


Attach the claw to install the lower steering column cover to the upper steering column cover.


b.
B427702C01
0.115,0.052 0.427,0.208 0.313,0.156 10 false *A 0.104,2.479 0.417,2.635 0.313,0.156 10 false *B
*A w/ Entry and Start System
*B w/o Entry and Start System


Install the screw.

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)


c.
B427700C01
0.083,0.042 0.396,0.198 0.313,0.156 10 false *A 0.135,2.552 0.448,2.708 0.313,0.156 10 false *B
*A w/ Entry and Start System
*B w/o Entry and Start System


With the steering wheel assembly facing straight ahead, turn the steering wheel 90° to the right and install the screw shown in the illustration.

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)


d.
B427701C02
0.115,0.052 0.427,0.208 0.313,0.156 10 false *A 0.125,2.51 0.438,2.667 0.313,0.156 10 false *B
*A w/ Entry and Start System
*B w/o Entry and Start System


With the steering wheel assembly facing straight ahead, turn the steering wheel 90° to the left and install the screw shown in the illustration.

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)


e.

Operate the tilt and telescopic lever to return the steering position to its original position.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION