The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the combination meter removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
45100
3.REMOVE STEERING WHEEL ASSEMBLY
55667
4.REMOVE INSTRUMENT PANEL REGISTER BEZEL GARNISH
55011A
5.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55410C
6.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
83100
7.REMOVE COMBINATION METER ASSEMBLY
Remove the 4 screws.
Disconnect the connector, detach the clamp and remove the combination meter assembly.