When the ignition switch is turned to ON, the combination meter assembly receives a signal of the front seat inner belt assembly RH If the driver side seat belt is not fastened, the combination meter assembly blinks the seat belt warning light. If the seat belt is fastened, the warning light goes off.
The front seat belt warning light on the combination meter assembly is used for both the driver side seat and front passenger side seat.
When replacing the combination meter assembly, make sure to replace it with a new one.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Driver Side Seat Belt | Seat belt warning light | OFF/ON | - |
| Tester Display |
|---|
| Driver Side Seat Belt |
The seat belt warning light on the combination meter assembly operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical /Combination Meter / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Driver Side Seatbelt Buckle Switch | Driver side seat belt buckle switch signal | ON or OFF | ON: Driver side seat belt unfastened
OFF: Driver side seat belt fastened |
- |
| Tester Display |
|---|
| Driver Side Seatbelt Buckle Switch |
| Result | Proceed to |
|---|---|
| ON or OFF is displayed on the GTS screen according to the driver side seat belt condition | A |
| ON or OFF is not displayed normally on the GTS screen according to the driver side seat belt condition | B |
A
B
Remove the front seat inner belt assembly RH.
for Manual Seat:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat)>REMOVAL
for Power Seat:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY(for Power Seat)>REMOVAL
Inspect the front seat inner belt assembly RH.
for Manual Seat:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY(for Manual Seat)>INSPECTION
for Power Seat:
Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY(for Power Seat)>INSPECTION
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for Manual Seat) | B |
| NG (for Power Seat) | C |
A
B
C
Disconnect the N16 front seat inner belt assembly RH connector.
Disconnect the G9 combination meter assembly connector.
Disconnect the 2L instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N16-3 - G9-3 (BKL) | Always | Below 1 Ω |
| N16-2 - Body ground | Always | Below 1 Ω |
| N16-3 or G9-3 (BKL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG