Home › Engine / Hybrid System › 1GD-FTV ENGINE CONTROL › ECM › 2015.08–2016.01
RM3270E _51 Engine / Hybrid System _041671 1GD-FTV ENGINE CONTROL _0203617 ECM A

1GD-FTV ENGINE CONTROL  ECM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the ECM removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of ECM
·

Learning values save

·

Learning values write

·

Vehicle Identification Number (VIN) registration


·

Engine starting

·

DTC P0630 is output


(Click here)

Performing iMT installation information reset


·

iMT system

·

DTCs are output


(Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.

PROCEDURE

Hide 55607 1.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Cover)

Hide 55550 2.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 89661 3.REMOVE ECM

A345997

a.

Disconnect the 2 4 wheel drive control ECU connectors, 6 ECM connectors and 3 clamps.


b.

Remove the bolt, 2 nuts and ECM with the 4 wheel drive control ECU.


Hide 89533 4.REMOVE 4 WHEEL DRIVE CONTROL ECU

Hide 89667A 5.REMOVE NO. 1 ECM BRACKET

a.
A345999

Remove the 2 screws and No. 1 ECM bracket.


Hide 89668A 6.REMOVE NO. 2 ECM BRACKET

a.
A346000

Remove the 2 screws and No. 2 ECM bracket.