Home › Engine / Hybrid System › 5L-E ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › from 2016.01
RM3270E _51 Engine / Hybrid System _048650 5L-E ENGINE MECHANICAL _0231148 FRONT CRANKSHAFT OIL SEAL A

5L-E ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the timing belt removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of timing belt Mode reset operation
·

Does not illuminate when replacement is necessary

·

Illuminates when replacement is not necessary


(Click here)

CAUTION:
A343695

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


PROCEDURE

Hide 13521P 2.REMOVE CRANKSHAFT TIMING PULLEY

a.
A378620C02
1.594,1.635 2.021,1.635 true 1.063,0.167 1.375,0.365 0.313,0.198 10 false *a 2.063,1.552 2.521,1.75 0.458,0.198 10 false SST
*a Hold
V100135

Turn


Using SST, remove the crankshaft timing pulley from the crankshaft.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05010, 09953-05020, 09954-05010)

HINT:

If the crankshaft timing pulley cannot be removed by using a screwdriver, remove it with SST.



Hide 11301C 3.REMOVE FRONT CRANKSHAFT OIL SEAL

a.
A056914C01
0.99,0.25 0.458,0.25 0.458,0.25 0.458,1.073 true 1.01,0.156 1.177,0.313 0.167,0.156 10 false *a
*a Cut Position


Using a knife, cut off the lip of the front crankshaft oil seal.


b.

Using a screwdriver, pry out the front crankshaft oil seal.

NOTICE:

Be careful not to damage the crankshaft and timing belt case sub-assembly.


HINT:
·

After removal, check the crankshaft for damage. If damaged, smooth the surface with #400 sandpaper.

·

Tape the screwdriver tip before use.