Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › KNOCK SENSOR › from 2016.01
RM3270E _51 Engine / Hybrid System _048729 1GR-FE ENGINE CONTROL _0231388 KNOCK SENSOR A

1GR-FE ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of knock sensor Inspection After Repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 11101 1.REMOVE CYLINDER HEAD SUB-ASSEMBLY RH (for Bank 1)

Hide 16332 2.REMOVE NO. 1 WATER OUTLET PIPE

a.
A356040

Detach the 3 wire harness clamps.


b.

for Type A:

Remove the 3 bolts and No. 1 water outlet pipe.


c.

for Type B:

Remove the 2 nuts, bolt and No. 1 water outlet pipe.


Hide 3.REMOVE KNOCK SENSOR

a.
A356041

Disconnect the 2 knock sensor connectors.


b.

Remove the 2 bolts and 2 knock sensors.