The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the cylinder head gasket removal/installation are shown below.
11302
1.REMOVE TIMING CHAIN COVER SUB-ASSEMBLY
16356
2.REMOVE REAR WATER BY-PASS JOINT
3.SET NO. 1 CYLINDER TO TDC/COMPRESSION
13540
4.REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY
13559
5.REMOVE CHAIN TENSIONER SLIPPER
13530
6.REMOVE IDLE SPROCKET ASSEMBLY
13562
7.REMOVE NO. 2 CHAIN VIBRATION DAMPER
13506
8.REMOVE CHAIN SUB-ASSEMBLY
13561
9.REMOVE NO. 1 CHAIN VIBRATION DAMPER
10.REMOVE CAMSHAFT TIMING GEARS AND NO. 2 CHAIN SUB-ASSEMBLY (for Bank 1)
13550
11.REMOVE NO. 2 CHAIN TENSIONER ASSEMBLY
12.REMOVE CAMSHAFT TIMING GEARS AND NO. 2 CHAIN SUB-ASSEMBLY (for Bank 2)
13560A
13.REMOVE NO. 3 CHAIN TENSIONER ASSEMBLY
14.REMOVE CAMSHAFT BEARING CAP (for Bank 1)
13511
15.REMOVE CAMSHAFT
13512
16.REMOVE NO. 2 CAMSHAFT
11811
17.REMOVE NO. 1 CAMSHAFT BEARING
11821
18.REMOVE NO. 2 CAMSHAFT BEARING
19.REMOVE CAMSHAFT BEARING CAP (for Bank 2)
13053
20.REMOVE NO. 3 CAMSHAFT SUB-ASSEMBLY
13054
21.REMOVE NO. 4 CAMSHAFT SUB-ASSEMBLY
11101
22.REMOVE CYLINDER HEAD SUB-ASSEMBLY
Using a 10 mm bi-hexagon wrench, uniformly loosen the 8 cylinder head set bolts in the sequence shown in the illustration and remove the 8 cylinder head set bolts and 8 plate washers.
Be careful not to drop the plate washers into the cylinder head sub-assembly.
Cylinder head sub-assembly warpage or cracking could result from removing bolts in the incorrect order.
Be sure to keep the removed parts separate for each installation position.
| *a | Protective Tape |
Remove the cylinder head sub-assembly.
Be careful not to damage the contact surfaces of the cylinder head sub-assembly and cylinder block sub-assembly.
If the cylinder head sub-assembly is difficult to lift off, pry between the cylinder head sub-assembly and cylinder block sub-assembly with a screwdriver.
Tape the screwdriver tip before use.
11115
23.REMOVE CYLINDER HEAD GASKET
11102
24.REMOVE CYLINDER HEAD LH
Uniformly loosen the 2 bolts in the sequence shown in the illustration and remove the 2 bolts.
Using a 10 mm bi-hexagon wrench, uniformly loosen the 8 cylinder head set bolts in the sequence shown in the illustration and remove the 8 cylinder head set bolts and 8 plate washers.
Be careful not to drop the plate washers into the cylinder head LH.
Cylinder head LH warpage or cracking could result from removing bolts in the incorrect order.
Be sure to keep the removed parts separate for each installation position.
| *a | Protective Tape |
Remove the cylinder head LH.
Be careful not to damage the contact surfaces of the cylinder head LH and cylinder block sub-assembly.
If the cylinder head LH is difficult to lift off, pry between the cylinder head LH and cylinder block sub-assembly with a screwdriver.
Tape the screwdriver tip before use.
11116
25.REMOVE NO. 2 CYLINDER HEAD GASKET
11101A
26.INSPECT CYLINDER HEAD SET BOLT
11101
27.INSPECT CYLINDER HEAD SUB-ASSEMBLY