Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR › from 2016.01
RM3270E _51 Engine / Hybrid System _048729 1GR-FE ENGINE CONTROL _0231389 AIR FUEL RATIO SENSOR A

1GR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
·

Replacement of air fuel ratio sensor

·

Gas leaks from exhaust system


Inspection After Repair Poor idle, engine start, etc. (Click here)

CAUTION:
·
A343694

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·
A358533

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.



PROCEDURE

Hide 17105 1.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

Hide 17104 2.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

Hide 89467B 3.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

a.

Disconnect the connector.


b.
A356044N01
2.104,0.729 2.427,0.729 false 2.469,0.635 2.792,0.844 0.323,0.208 10 false SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold.

SST
09224-00011  

NOTICE:

Do not damage the air fuel ratio sensor.



Hide 89467B 4.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

a.

Disconnect the connector.


b.
A356045N01
2.448,1.01 2.833,1.01 false 2.875,0.927 3.208,1.104 0.333,0.177 10 false SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold.

SST
09224-00011  

NOTICE:

Do not damage the air fuel ratio sensor.