The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor, exhaust manifold sub-assembly LH, exhaust manifold sub-assembly RH, front exhaust pipe assembly and front No. 2 exhaust pipe assembly removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
53737B
1.REMOVE FRONT UPPER FENDER APRON SEAL LH
53736
2.REMOVE FRONT UPPER FENDER APRON SEAL RH
53882F
3.REMOVE FRONT FENDER SEAL LH
53882F
4.REMOVE FRONT FENDER SEAL RH
17450B
5.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
17410
6.REMOVE FRONT EXHAUST PIPE ASSEMBLY
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Disconnect the heated oxygen sensor connector.
Detach the 2 clamps.
Remove the 2 bolts, 2 compression springs and 2 nuts.
Disconnect the No. 1 exhaust pipe support and remove the front exhaust pipe assembly.
Remove the 2 gaskets.
37140
7.REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)
for except TSAM Made
Click hereDrivetrain>DRIVE SHAFT / PROPELLER SHAFT>FRONT PROPELLER SHAFT ASSEMBLY(except TSAM Made)>REMOVAL
17119
8.REMOVE NO. 2 MANIFOLD STAY
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove the 3 bolts and No. 2 manifold stay.
17105
9.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Disconnect the air fuel ratio sensor connector.
Remove the 6 nuts, exhaust manifold sub-assembly LH and gasket.
89467B
10.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
17118
11.REMOVE MANIFOLD STAY
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove the 3 bolts and manifold stay.
17104
12.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Disconnect the air fuel ratio sensor connector.
Remove the 6 nuts, exhaust manifold sub-assembly RH and gasket.
89467B
13.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)