89467B
1.INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
Click hereEngine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
| *a | Torque Wrench Fulcrum Length |
Using SST, install the air fuel ratio sensor to the exhaust manifold.
Do not damage the air fuel ratio sensor.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 38 N*m (387 kgf*cm, 28 ft.*lbf)
Connect the connector.
89467B
2.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
Click hereEngine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
| *a | Torque Wrench Fulcrum Length |
Using SST, install the air fuel ratio sensor to the exhaust manifold.
Do not damage the air fuel ratio sensor.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 38 N*m (387 kgf*cm, 28 ft.*lbf)
Connect the connector.
17105
3.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH
17104
4.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
5.INSPECT FOR EXHAUST GAS LEAK