1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
16361A
2.REMOVE FAN AND GENERATOR V BELT
for 1GD-FTV:
Click hereEngine / Hybrid System>1GD-FTV ENGINE MECHANICAL>DRIVE BELT>REMOVAL
for 2GD-FTV:
27415
3.REMOVE GENERATOR WITH CLUTCH PULLEY
for 1GD-FTV:
Click herePower Source / Network>1GD-FTV BATTERY / CHARGING>GENERATOR>REMOVAL
for 2GD-FTV:
Click herePower Source / Network>2GD-FTV BATTERY / CHARGING>GENERATOR>REMOVAL
4.REMOVE FRONT WHEEL LH
53737B
5.REMOVE FRONT FENDER APRON SEAL LH
Remove the 6 clips and front fender apron seal LH.
88711
6.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
| *A | w/o Thermostat |
| *B | w/ Thermostat |
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor assembly with magnet clutch.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88704
7.DISCONNECT SUCTION HOSE SUB-ASSEMBLY
| *A | w/o Thermostat |
| *B | w/ Thermostat |
Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with magnet clutch.
Remove the O-ring from the suction hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
8.REMOVE COMPRESSOR ASSEMBLY WITH MAGNET CLUTCH
| *A | w/o Thermostat |
| *B | w/ Thermostat |
Disconnect the connector.
Detach the clamp.
| *A | w/o Thermostat |
| *B | w/ Thermostat |
|
Bolt |
|
Nut |
Remove the 2 bolts and 2 nuts.
| *A | w/o Thermostat |
| *B | w/ Thermostat |
Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor assembly with magnet clutch.
Remove the compressor assembly with magnet clutch from the vehicle with the stud bolt remaining in the compressor assembly with magnet clutch.