Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
55667
1.REMOVE INSTRUMENT PANEL REGISTER BEZEL GARNISH
55011A
2.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55012A
3.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55405B
4.REMOVE INSTRUMENT CENTER CLUSTER FINISH PANEL SUB-ASSEMBLY
55905J
5.REMOVE CONTROL KNOB SUB-ASSEMBLY
Remove the 2 control knob sub-assemblies.
84013A
6.REMOVE INTEGRATION PANEL SUB-ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY
|
Place Hands here |
|
Remove in this Direction |
Put protective tape around the integration panel sub-assembly.
Detach the clip and remove the integration panel sub-assembly with air conditioning control assembly.
Disconnect the 3 connectors.
55906A
7.DISCONNECT DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY
Detach the claw and disconnect the defroster damper control cable sub-assembly.
55909A
8.DISCONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY
Detach the claw and disconnect the air mix damper control cable sub-assembly.