| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C1268 | Transfer L4 Position Switch Circuit | The skid control ECU receives an L4 abnormal status signal from the 4 wheel drive control ECU via CAN. | ·
Touch select 2-4 and high-low system ·
Skid control ECU (Brake actuator assembly) |
- |
When replacing the skid control ECU (brake actuator assembly), perform Test Mode (Signal Check) to acquire the rear differential lock identification information.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE
When DTC U0114 is output together with DTC C1268, inspect and repair the trouble areas indicated by DTC U0114 first.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>U0073
Turn the 4WD control switch (transfer position switch) to L4, and then drive the vehicle and check that there are no problems with the touch select 2-4 and high-low system.
There are no problems with the touch select 2-4 and high-low system.
| Result |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch off.
Start the engine.
Turn the 4WD control switch (transfer position switch) to H2 or H4.
Turn the 4WD control switch (transfer position switch) to L4, drive the vehicle, and then check for DTCs.
| Proceed to |
|---|
| DTC is not output |
| DTC is output |
DTC is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC is output