Home › Engine / Hybrid System › 1KD-FTV COOLING › THERMOSTAT › from 2016.01
RM3270E _51 Engine / Hybrid System _048919 1KD-FTV COOLING _0237577 THERMOSTAT A

1KD-FTV COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16331A 1.INSTALL THERMOSTAT

a.
A301805C06
1.552,1.073 1.552,1.188 false 2.75,1.115 2.75,1.229 false 1.323,3.604 2.333,3.604 true 2.406,3.521 2.719,3.719 0.313,0.198 10 false *a 1.469,0.438 1.781,0.635 0.313,0.198 10 false *b 1.469,1.24 1.781,1.438 0.313,0.198 10 false *1 2.677,1.24 2.99,1.438 0.313,0.198 10 false *1 2.677,0.438 2.99,0.635 0.313,0.198 10 false *c 1.021,3.135 1.354,3.333 0.333,0.198 10 false 30° 1.385,3.135 1.719,3.333 0.333,0.198 10 false 30°
*1 Gasket
*a Jiggle Valve
*b CORRECT
*c INCORRECT
V100135

Upward


Install a new gasket to the thermostat.

NOTICE:

When installing the gasket to the thermostat, be careful not to deform the gasket. Make sure that the groove of the gasket is properly installed to the thermostat, as shown in the illustration.



b.

Insert the thermostat into the cylinder block with the jiggle valve facing straight upward.

HINT:

The jiggle valve may be set within 30° of either side of the prescribed position.



Hide 16321 2.INSTALL WATER INLET

a.

Install the water inlet with the 3 bolts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


b.

Connect the wire harness with the bolt to the water inlet.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 16572D 3.CONNECT NO. 2 RADIATOR HOSE

a.

Connect the No. 2 radiator hose to the water inlet.


Hide 32909 4.CONNECT AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP (for Automatic Transmission)

a.

Connect the automatic transmission oil cooler tube clamp to the water inlet with the bolt.

Torque:
13.5 N*m (138 kgf*cm, 10 ft.*lbf)


Hide 17801 8.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17705 9.INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE

Hide 51410 12.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 17940D 13.INSTALL INTERCOOLER ASSEMBLY