Home › Engine / Hybrid System › 5L-E FUEL › FUEL INJECTION PUMP › from 2016.01
RM3270E _51 Engine / Hybrid System _049532 5L-E FUEL _0237408 FUEL INJECTION PUMP A

5L-E FUEL  FUEL INJECTION PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the injection pump assembly removal/installation are shown below.

Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Timing belt Mode reset operation
·

Does not illuminate when replacement is necessary

·

Illuminates when replacement is not necessary


Click here(Click here)

PROCEDURE

Hide 23701 3.REMOVE INJECTION PIPE SUB-ASSEMBLY

Hide 13613P 4.REMOVE INJECTION PUMP DRIVE PULLEY

a.
A370248N01
0.26,1.448 0.26,1.281 0.26,1.281 1.021,0.802 true 0.26,1.281 0.885,0.573 true 0.125,1.458 0.583,1.656 0.458,0.198 10 false SST

Using SST, remove the nut.

SST
09213-14010  
09330-00021  (91651-60865)


b.
A370249N01
1.229,1.021 2.021,1.469 2.021,1.469 2.271,1.469 true 2.344,1.396 2.802,1.594 0.458,0.198 10 false SST

Using SST, remove the injection pump drive pulley from the injection pump assembly.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05010, 09954-05021)


Hide 22100 5.REMOVE INJECTION PUMP ASSEMBLY

a.

Slide the 3 clamps and disconnect the 3 fuel hoses from the injection pump assembly.


b.
A370250

Disconnect the 7 connectors and detach the wire harness clamp.


c.
A370305C01
0.438,2.854 0.438,2.698 0.438,2.698 0.76,2.49 true 1.552,2.948 1.354,2.948 1.354,2.948 0.979,2.479 true 0.354,2.844 0.667,3 0.313,0.156 10 false *a 1.594,2.854 1.833,3.031 0.24,0.177 10 false *b
*a Mark (Timing Gear Case Sub-assembly Side)
*b Mark (Injection Pump Assembly Side)


Remove the 3 bolts and No. 1 injection pump stay from the cylinder block sub-assembly and injection pump assembly.


d.

Before removing the injection pump assembly, check if the marks are aligned.

If not, place new marks for reinstallation.


e.

Remove the 2 nuts and injection pump assembly from the timing gear case sub-assembly.