Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › from 2016.01
RM3270E _58 Vehicle Interior _041706 THEFT DETERRENT / KEYLESS ENTRY _0212881 THEFT DETERRENT SYSTEM J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  Unlock Warning Switch Circuit  


DESCRIPTION

The unlock warning switch assembly comes on when the ignition key is inserted into the ignition key cylinder and goes off when the ignition key is removed.

WIRING DIAGRAM

E318148E07
4.49,0.875 4.948,1.073 0.458,0.198 10 false KSW 4.25,0.875 4.708,1.073 0.458,0.198 10 false 8 3.292,0.875 3.75,1.073 0.458,0.198 10 false 1 1.781,0.875 2.24,1.073 0.458,0.198 10 false 2 4.885,2.01 5.344,2.208 0.458,0.198 10 false G33 4.906,2.167 6.625,2.365 1.719,0.198 10 false Body ECU 5.917,0.573 6.375,0.771 0.458,0.198 10 false +B 1.521,1.24 1.979,1.438 0.458,0.198 10 false G136 1.531,1.417 3.677,1.646 2.146,0.229 10 false Unlock Warning Switch Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

w/ Automatic Light Control System:

If the body ECU has been replaced, it is necessary to initialize the body ECU.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION

·

w/ Door Control Battery:

As the door control battery is installed between the vehicle battery and body ECU, first perform the inspections to confirm that there are no malfunctions in the power source circuit for the body ECU before performing this troubleshooting procedure.

Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PRECAUTION



PROCEDURE

1.INSPECT UNLOCK WARNING SWITCH ASSEMBLY
a.

Remove the unlock warning switch assembly.

Click hereVehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>REMOVAL


b.

Inspect the unlock warning switch assembly.

Click hereVehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH ASSEMBLY - BODY ECU AND BODY GROUND)

NG

REPLACE UNLOCK WARNING SWITCH ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH ASSEMBLY - BODY ECU AND BODY GROUND)
a.

Disconnect the G33 body ECU connector.


b.

Disconnect the G136 unlock warning switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G33-8 (KSW) - G136-1 Always Below 1 Ω
G33-8 (KSW) - Body ground Always 10 kΩ or higher
G136-1 - Body ground Always 10 kΩ or higher
G136-2 - Body ground Always Below 1 Ω



Result:
Result
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR