Home › Vehicle Interior › DOOR LOCK › UNLOCK WARNING SWITCH › from 2016.01
RM3270E _58 Vehicle Interior _041705 DOOR LOCK _0214191 UNLOCK WARNING SWITCH A

DOOR LOCK  UNLOCK WARNING SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for RHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45287 3.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 4.REMOVE UPPER STEERING COLUMN COVER

Hide 89782 5.REMOVE TRANSPONDER KEY COIL (w/ Engine Immobiliser System)

Hide 69057A 6.REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY

Hide 84052 7.REMOVE UNLOCK WARNING SWITCH ASSEMBLY

a.
B406704C01
1.552,1.083 1.948,1.698 1.948,1.698 2.24,1.698 true 2.844,0.635 2.938,0.76 2.938,0.76 3.031,0.76 true 3.052,0.646 3.302,0.875 0.25,0.229 10 true *a 2.25,1.594 2.5,1.823 0.25,0.229 10 true *a
*a Center Part
V113147

Remove in this Direction


Detach the connector.


b.

Push up the center part of the unlock warning switch assembly, detach the claw and remove the unlock warning switch assembly.

HINT:

Slide the unlock warning switch assembly in the direction indicated by the arrow in the illustration to remove it.