When the intrusion sensor cancel switch on the map light assembly is pressed, the sensor off signal is sent to the body ECU which causes the intrusion sensor to stop operating.
w/ Door Control Battery:
As the door control battery is installed between the vehicle battery and body ECU, first perform the inspections to confirm that there are no malfunctions in the power source circuit for the body ECU before performing this troubleshooting procedure.
w/ Automatic Light Control System:
If the body ECU has been replaced, it is necessary to initialize the body ECU.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
Disconnect the G33 body ECU connector.
Disconnect the Q2 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G33-10 (SSW1) - Q2-7 (IND2) | Always | Below 1 Ω |
| Q2-3 (GND) - Body ground | Always | Below 1 Ω |
| G33-10 (SSW1) - Body ground | Always | 10 kΩ or higher |
| Q2-7 (IND2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the map light assembly (intrusion sensor cancel switch).
Click hereVehicle Interior>LIGHTING (INT)>MAP LIGHT BULB>REPLACEMENT
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (IND2) - 3 (GND) | Intrusion sensor cancel switch not pressed | 10 kΩ or higher |
| 7 (IND2) - 3 (GND) | Intrusion sensor cancel switch pressed | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
for LHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL
for RHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL
NG