Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 1KD-FTV, 2KD-FTV) › from 2016.01
RM3270E _54 Brake _041692 BRAKE SYSTEM (OTHER) _0244529 VACUUM PUMP(for 1KD-FTV, 2KD-FTV) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1KD-FTV, 2KD-FTV)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

The vacuum pump assembly is listed as one of the 200000 km (124000 mile) maintenance parts. Make sure to disassemble and inspect it every 200000 km (124000 miles) and replace parts as necessary.


PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 51442 2.REMOVE NO. 2 ENGINE UNDER COVER

Hide 16400 3.REMOVE RADIATOR ASSEMBLY

Hide 11322A 4.REMOVE NO. 1 TIMING BELT COVER (for 1KD-FTV)

Hide 11322A 5.REMOVE NO. 1 TIMING BELT COVER (for 2KD-FTV)

Hide 29300 6.REMOVE VACUUM PUMP ASSEMBLY

a.

Disconnect the 2 vacuum hoses from the vacuum pump assembly.


b.
C111342

Remove the 2 nuts and pull out the vacuum pump assembly from the engine.


c.

Remove the 2 O-rings.


Hide 29369 7.REMOVE CHECK VALVE SUB-ASSEMBLY

a.
C111343

Mount the vacuum pump assembly in a vise

NOTICE:

Place aluminum plates on the vise to prevent damage to the vacuum pump assembly.



b.

Remove the union bolt, union and 2 gaskets.


c.
C111344

Remove the check valve sub-assembly and gasket.


Hide 8.REMOVE VACUUM PUMP END COVER

a.
C111345

Remove the 3 bolts.


b.
C111346

Using a 5 mm pin punch and hammer, tap out the 2 straight pins.


c.

Remove the vacuum pump end cover and 2 O-rings.


Hide 9.REMOVE VACUUM PUMP BLADE

a.
C111347

Remove the rotor together with the 5 vacuum pump blades.

NOTICE:

Be careful not to drop the blades.



b.

Remove the 5 vacuum pump blades from the vacuum pump rotor sub-assembly.


Hide 29351 10.REMOVE VACUUM PUMP GEAR

a.
C111348

Mount the vacuum pump gear in a vise.

NOTICE:

Place aluminum plates on the vise to prevent damage to the vacuum pump gear.



b.

Remove the gear lock nut.


c.

Remove the vacuum pump gear and woodruff key.


Hide 11.REMOVE VACUUM PUMP SHAFT

a.
C111349

Using snap ring pliers, remove the snap ring.


b.
C111350

Using a plastic-faced hammer, tap out the vacuum pump shaft.


Hide 12.REMOVE VACUUM PUMP BEARING

a.
C111351

Using a 17 mm socket wrench and press, press out the vacuum pump bearing.