Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL › from 2016.01
RM3270E _54 Brake _041692 BRAKE SYSTEM (OTHER) _0205355 BRAKE PEDAL A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55302A 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 47101A 4.REMOVE BRAKE PEDAL RETURN SPRING

a.
C323748

Remove the brake pedal return spring from the brake pedal support sub-assembly and push rod pin.


Hide 47264A 5.REMOVE PUSH ROD PIN

a.
C323747

Remove the clip from the push rod pin.


b.

Remove the push rod pin from the brake master cylinder push rod clevis.


Hide 55106 6.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY

a.
C323705

Disconnect the connector from the stop light switch assembly.


b.

Detach the 2 clamps from the brake pedal support sub-assembly.


c.
C323706

Remove the brake pedal support reinforcement set bolt.


d.
C323707

Remove the 4 nuts and brake pedal support sub-assembly.


e.

Remove the nut from the brake pedal support sub-assembly.


Hide 84340 7.REMOVE STOP LIGHT SWITCH ASSEMBLY