1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
53882F
3.REMOVE FRONT FENDER SEAL LH
28100
4.REMOVE STARTER ASSEMBLY
Disconnect the starter connector.
Remove the bolt and disconnect the starter wire from the cylinder block.
Disconnect the terminal cap.
Remove the nut and disconnect the starter wire.
Remove the bolt and disconnect the wire harness bracket.
Remove the 2 bolts and starter assembly.
11363A
5.REMOVE FLYWHEEL HOUSING SIDE COVER
Remove the flywheel housing side cover from the cylinder block.