Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2016.01
RM3270E _51 Engine / Hybrid System _041679 CRUISE CONTROL _0199359 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0503  Vehicle Speed Sensor "A" Intermittent / Erratic / High  


DESCRIPTION

The skid control ECU (brake actuator assembly) outputs the vehicle speed signal to the ECM through the combination meter assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
P0503 Vehicle Speed Sensor "A" Intermittent / Erratic / High Cruise control in operation: When the ECM receives sudden changes in the vehicle speed signal
·

Vehicle stability control system*1

·

Anti-lock brake system*2

·

Meter / gauge system

·

ECM



*1: w/ Vehicle Stability Control System

*2: w/o Vehicle Stability Control System


CAUTION / NOTICE / HINT

·

This DTC may be output by the brake control system at the same time. In that case, perform troubleshooting for the brake control system first.

·

When replacing the combination meter assembly, make sure to replace it with a new one.


PROCEDURE

1.CHECK FOR DTCs (BRAKE CONTROL SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.


e.

Check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
Vehicle stability control system DTCs are output (w/ Vehicle Stability Control System) B
Anti-lock brake system DTCs are output (w/o Vehicle Stability Control System) C



A

2.CHECK COMBINATION METER SYSTEM (SPEED SIGNAL CIRCUIT)

B

C

2.CHECK COMBINATION METER SYSTEM (SPEED SIGNAL CIRCUIT)
a.

Check the circuits that send vehicle speed signals to this system in the combination meter system.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>Speed Signal Circuit


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)
3.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 237

b.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which cruise control operation is possible.


ii.

Turn the cruise control system on using the cruise control main switch (ON/OFF).


iii.

Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.



c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 237

Result:
Result Proceed to
DTC P0503 is output A
DTC P0503 is not output B



A

B

END