Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK › from 2016.01
RM3270E _58 Vehicle Interior _041705 DOOR LOCK _0205680 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front door lock removal/installation are shown below.

Necessary Procedures After Parts Removed / Installed / Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal
w/ Power Back Door System:

Reset back door close position


Power back door system (Click here)

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.

·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for RHD vehicles.

·

Fully open the front door glass sub-assembly RH before proceeding with work.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67491A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH RH

Hide 74210 4.REMOVE FRONT ARMREST ASSEMBLY RH

Hide 5.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 69283 7.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG RH

Hide 67601 8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH

Hide 67831 9.REMOVE FRONT DOOR SERVICE HOLE COVER RH

Hide 68141C 10.REMOVE FRONT DOOR GLASS RUN RH

Hide 68101 11.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY RH

Hide 67403F 12.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY RH

Hide 13.REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

Hide 69310 14.REMOVE FRONT DOOR LOCK ASSEMBLY RH

a.
B441600C01
0.063,0.042 0.375,0.24 0.313,0.198 10 true *A 0.073,2.531 0.385,2.729 0.313,0.198 10 true *B
*A w/o Double Locking System
*B w/ Double Locking System
V100135

"Torx" Screw
V100136

Connector


Disconnect the connector.


b.

Using a T30 "TORX" socket wrench, remove the 3 screws.


c.
B441624C01
0.865,0.583 1.427,0.583 true 0.75,0.5 1.063,0.698 0.313,0.198 10 true *1
*1 Front Door Lock Open Rod RH
V113147

Remove in this Direction


Disconnect the front door lock open rod RH and remove the front door lock assembly RH as shown in the illustration.


Hide 69035A 15.REMOVE FRONT DOOR LOCK COVER SUB-ASSEMBLY RH (w/o Double Locking System)

a.
B399668C01
0,0 0,0 false
V100155

Protective Tape


Using a thin-bladed screwdriver, detach the claw and clamp and remove the front door lock cover sub-assembly RH from the front door lock assembly RH.

HINT:

Tape the thin-bladed screwdriver tip before use.



Hide 69750C 16.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY RH

a.
B404256C01
0,0 0,0 false
V113147

Remove in this Direction


w/o Double Locking System:

Detach the guide and remove the front door inside locking cable assembly RH from the front door lock assembly RH.


b.

w/ Double Locking System:

i.
B441627

Detach the claw and open the cover.


ii.
B441628

Detach the guide and remove the front door lock remote cable assembly RH from the front door lock assembly RH.



Hide 69710B 17.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY RH

a.
B404257C01
0,0 0,0 false
V113147

Remove in this Direction


w/o Double Locking System:

Detach the guide and remove the front door lock remote cable assembly RH from the front door lock assembly RH.


b.
B441626C01
0,0 0,0 false
V113147

Remove in this Direction


w/ Double Locking System:

Detach the guide and remove the front door inside locking cable assembly RH from the front door lock assembly RH.


Hide 69318C 18.REMOVE DOOR LOCK WIRING HARNESS SEAL

a.
B441625C01
0.083,0.104 0.396,0.302 0.313,0.198 10 false *A 0.125,1.958 0.438,2.156 0.313,0.198 10 false *B
*A w/o Double Locking System
*B w/ Double Locking System
V113147

Remove in this Direction


Remove the door lock wiring harness seal from the front door lock assembly RH.