Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL SYSTEM(w/ Differential Lock) › from 2016.01
RM3270E _52 Drivetrain _041686 AXLE AND DIFFERENTIAL _0248598 DIFFERENTIAL SYSTEM(w/ Differential Lock) C

AXLE AND DIFFERENTIAL  DIFFERENTIAL SYSTEM(w/ Differential Lock)  P17C1  Rear Differential Lock Solenoid Circuit High  


DESCRIPTION

This DTC is output when a malfunction is detected due to a battery short occurring in the differential lock coil drive circuit of the rear differential.

DTC No. Detection Item DTC Detection Condition Trouble Area
P17C1 Rear Differential Lock Solenoid Circuit High
·

Diagnosis Condition: Directly after ignition switch is turned to ON, or when rear differential is switched between free and locked (differential lock coil operating) with ignition switch turned to ON

·

Malfunction Status: Battery short in differential lock coil drive circuit

·

Malfunction Time: 0.05 seconds or more

·

Other: 1 trip detection logic


·

Wire harness and connector

·

4 wheel drive control ECU

·

Differential lock coil



PROCEDURE

1.CHECK DIFFERENTIAL LOCK COIL
a.

Disconnect the C61 4 wheel drive control ECU connector.


b.
C142292C04
1.542,0.854 1.927,1.135 0.385,0.281 1.125,1.74 0.656,1.271 true 1.115,2.198 0.531,2.75 true 1.615,0.917 2.073,1.115 0.458,0.198 10 false C61 0.479,1.073 1,1.271 0.521,0.198 10 false SL+ 0.365,2.792 0.823,2.99 0.458,0.198 10 false SL- 0.146,0.073 0.458,0.271 0.313,0.198 10 false *a
*a Front view of wire harness connector
(to 4 Wheel Drive Control ECU)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
C61-1 (SL+) or C61-5 (SL-) - Body ground Ignition switch ON Below 1 V



Result:
Proceed to
OK
NG



OK

REPLACE 4 WHEEL DRIVE CONTROL ECU

NG

2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - DIFFERENTIAL LOCK COIL)
2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - DIFFERENTIAL LOCK COIL)
a.

Disconnect the C61 4 wheel drive control ECU connector.


b.

Disconnect the e1 differential lock coil connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
C61-1 (SL+) or e1-2 (M1) - Body ground Ignition switch ON Below 1 V
C61-5 (SL-) or e1-1 (M2) - Body ground Ignition switch ON Below 1 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR