Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for RHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
73560
1.INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY RH
| *a | Bolt A |
| *b | Bolt B |
Attach the 2 guides and temporarily install the retractor of the rear No. 2 seat outer belt assembly RH with the 2 bolts.
Tighten the 2 bolts in the order shown in the illustration.
Connect the rear No. 2 seat outer belt assembly RH with the bolt.
73178B
2.INSTALL SEAT BELT ANCHOR COVER CAP
62511
3.INSTALL QUARTER INSIDE TRIM BOARD RH
73560
4.INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY RH (for Floor Anchor)
Connect the floor anchor of the rear No. 2 seat outer belt assembly RH with the bolt.
73360C
5.INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH (for Floor Anchor)
Connect the floor anchor of the rear No. 1 seat outer belt assembly RH with the bolt.
73233B
6.INSTALL REAR NO. 2 SEAT OUTER LAP BELT ANCHOR COVER
73233A
7.INSTALL REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
67935
8.INSTALL BACK DOOR SCUFF PLATE
67917C
9.INSTALL REAR DOOR SCUFF PLATE RH
10.INSTALL REAR NO. 2 SEAT ASSEMBLY LH