Home › General › INTRODUCTION › REPAIR INSTRUCTION
RM1880E _V1 General _013205 INTRODUCTION _0068351 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL


Procedures Necessary when Cable is Disconnected/Reconnected to Battery Terminal
Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed See page
for Driver Side, w/ Jam Protection Function
Power window regulator motor initialization
·

Jam protection function

·

Power window control system (w/ Jam Protection Function)


(Click here)


PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Procedures Necessary when ECU or Other Parts are Replaced
Replacement Part Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed See Page
w/ Theft Deterrent System
·

Theft warning ECU assembly

·

Key


Recognition code registration Wireless door lock control system (Click here)
w/o Theft Deterrent System
·

Door control receiver

·

Key


Recognition code registration Wireless door lock control system (Click here)
·

Transponder key ECU assembly

·

ECM

·

KEY


Code registration Engine starting Refer to the Service Bulletin for the registration procedure.
for Driver Side, w/ Jam Protection
·

Front power window regulator motor

·

Power window regulator

·

Power window regulator master switch


Motor initialization
·

Jam protection function

·

Power window control system (w/ Jam Protection Function)


(Click here)