Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM1880E _51 Engine / Hybrid System _013209 2TR-FE ENGINE CONTROL _0068455 CRANKSHAFT POSITION SENSOR A

2TR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 2.DISCONNECT COOLER COMPRESSOR ASSEMBLY

a.
A255049

Remove the bolt and disconnect the suction hose sub-assembly from the engine.


b.
G039332

Disconnect the cooler compressor connector.


c.

Remove the 4 bolts and disconnect the cooler compressor from the engine.


d.

Support the cooler compressor securely.

HINT:

It is not necessary to completely remove the cooler compressor. With the hoses connected to the compressor, hang the compressor on the vehicle body with a rope.



Hide 3.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET

Hide 4.REMOVE CRANKSHAFT POSITION SENSOR

a.
A253316

Disconnect the crankshaft position sensor connector.


b.

Disconnect the crankshaft position sensor connector from the connector bracket.


c.

Detach the harness clamp.


d.

Remove the bolt and crankshaft position sensor.