Home › Engine / Hybrid System › 2TR-FE ENGINE MECHANICAL › ENGINE UNIT › 2011.07–2012.09
RM1880E _51 Engine / Hybrid System _013210 2TR-FE ENGINE MECHANICAL _0068471 ENGINE UNIT A

2TR-FE ENGINE MECHANICAL  ENGINE UNIT  REMOVAL  


PROCEDURE

Hide 2.REMOVE PCV PIPE

a.

Disconnect the PCV hose from the PCV valve sub-assembly and intake manifold.


b.

Remove the bolt and PCV pipe.


Hide 4.REMOVE ENGINE WIRE

a.

Disconnect the oil pressure switch connector.


b.

Disconnect the noise filter connector.


c.

Disconnect the camshaft position sensor connector.


d.

Disconnect the 4 injector connectors.


e.

Disconnect the crankshaft position sensor connector.


f.

Disconnect the camshaft timing oil control valve connector.


g.

Disconnect the purge VSV connector.


h.

Disconnect the throttle body connector.


i.

Disconnect the engine coolant temperature sensor connector.


j.

Disconnect the knock sensor connector.


k.

Disconnect the wire harness from the clamps.


l.

Remove the 2 bolts and wire harness from the engine.


Hide 5.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 6.REMOVE FUEL DELIVERY PIPE WITH FUEL INJECTOR

Hide 8.REMOVE INTAKE MANIFOLD

a.

Disconnect the crankshaft position sensor from the clamp.


b.
G036020

Remove the 5 bolts, 2 nuts, intake manifold and gasket.


Hide 9.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

Hide 11.REMOVE IDLE PULLEY ASSEMBLY

a.
A329590

Loosen the bolt and then remove the idle pulley assembly.

HINT:

The bolt in the illustration cannot be removed from the idle pulley assembly.



Hide 12.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET

a.
A099203

Remove the 5 bolts and No. 1 compressor mounting bracket.


Hide 13.REMOVE NO. 1 IDLER PULLEY SUB-ASSEMBLY

Hide 14.REMOVE HEATER WATER INLET HOSE

Hide 15.REMOVE HEATER WATER OUTLET HOSE

Hide 16.REMOVE NO. 1 WATER BY-PASS PIPE

a.
A222413

Remove the 2 nuts, water by-pass pipe and gasket.


Hide 17.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH

a.
A099872

Remove the 4 bolts and engine mounting bracket.


Hide 18.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET RH

a.
A099873

Remove the 4 bolts and engine mounting bracket.