Home › Engine / Hybrid System › 2TR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM1880E _51 Engine / Hybrid System _013210 2TR-FE ENGINE MECHANICAL _0068469 REAR CRANKSHAFT OIL SEAL A

2TR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)

Hide 2.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

Hide 3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

Hide 4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 5.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

a.
A099210
0.885,1.427 0.667,1.583 0.667,1.583 1.219,1.708 false 0.333,1.5 0.708,1.698 0.375,0.198 10 false SST

Using SST, hold the crankshaft.

SST
09213-54015  (91651-60855)
09330-00021  


b.
A252562

Remove the 10 bolts and flywheel.


Hide 6.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

a.
G038108
2.25,1.573 2.25,1.813 false 1.344,1.49 0.865,1.375 false 2.115,1.875 2.646,2.063 0.531,0.188 10 false SST 0.521,1.281 0.979,1.5 0.458,0.219 10 false SST

Using SST, hold the crankshaft.

SST
09213-54015  (91651-60855)
09330-00021  


b.
A252563

Remove the 10 bolts, rear drive plate spacer, drive plate and front drive plate spacer.


Hide 7.REMOVE REAR CRANKSHAFT OIL SEAL

a.
A252564
1.052,1.948 0.938,1.948 0.938,1.948 0.688,1.573 true 1.75,1.156 2.042,1.75 2.042,1.75 2.177,1.75 true 1.083,1.854 1.396,2.063 0.313,0.208 10 false *1 2.229,1.635 2.573,1.854 0.344,0.219 10 true *2
*1 Cut Position
*2 Protective Tape


Using a knife, cut off the lip of the oil seal.


b.

Using a screwdriver, pry out the oil seal.

NOTICE:
·

Do not damage the surface of the oil seal press fit hole or the crankshaft.

·

After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.



HINT:

Tape the screwdriver tip before use.