1.INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
| *1 | O-Ring |
Apply a light coat of spindle oil or gasoline to a new O-ring and install the O-ring to the fuel pressure regulator.
Install the fuel pressure regulator with the 3 bolts.
Connect the vacuum hose.
Attach the wire harness clamp.
Connect the throttle body connector.
Connect the purge VSV connector.
2.CONNECT NO. 2 FUEL HOSE
3.INSTALL INTAKE AIR CONNECTOR
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
5.INSPECT FOR FUEL LEAK