1.INSTALL STUD BOLT
If a stud bolt is deformed or its threads are damaged, replace it.
Using an E6 "TORX" socket wrench, install the 2 stud bolts to the intake manifold.
2.INSTALL INTAKE MANIFOLD
Install the purge line hose to the intake manifold.
Install the 2 wire harness clamp brackets to the intake manifold with the 2 bolts.
Install a new gasket to the intake manifold.
|
Bolt |
|
Nut |
Install the intake manifold with the 5 bolts and 2 nuts, and tighten the bolts and nuts in the sequence shown in the illustration.
for Automatic Transmission:
Install the oil filler tube bracket with the bolt.
Connect the No. 3 PCV hose and vacuum hose to the intake manifold.
Attach the No. 2 water by-pass hose.
for RHD:
Connect the engine wire with the bolt.
Attach the No. 1 fuel hose to the intake manifold.
Attach the 3 wire harness clamps to the 2 wire harness clamp brackets.
3.INSTALL PURGE VSV
4.INSTALL FRONT UPPER FENDER APRON SEAL
Install the front upper fender apron seal with the 6 clips.
5.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
6.INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)
7.INSTALL STARTER ASSEMBLY
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).