Home › Engine / Hybrid System › 2TR-FE COOLING › WATER PUMP
RM1880E _51 Engine / Hybrid System _013214 2TR-FE COOLING _0068492 WATER PUMP G

2TR-FE COOLING  WATER PUMP  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK

HINT:
·

The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, coolant residue (solids) may be found on the drain plug or the bottom of the engine water pump assembly. Engine coolant may leak if foreign matter enters the engine water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces.

·

Before performing this inspection, check that there is no coolant leaking from any parts other than the water pump. If there are leaks, inspect those areas.

·

Perform this inspection when the engine is cold.



a.

Visually check the engine water pump assembly.

i.

Check that engine coolant is not dripping from the engine water pump assembly.

HINT:
·

If engine coolant is dripping, replace the engine water pump assembly.

·

If engine coolant is not dripping, perform the following check.





Hide 3.INSPECT ENGINE WATER PUMP ASSEMBLY

a.
A301321
0.438,1.625 0.438,0.719 0.438,0.719 0.292,0.719 true 2.188,0.927 2.583,0.302 2.583,0.302 2.729,0.302 true 2.771,0.208 3.083,0.406 0.313,0.198 10 false *2 0.125,0.615 0.438,0.813 0.313,0.198 10 false *1
*1 Water Hole
*2 Air Hole
V100135

Turn


Visually check the air hole and water hole for coolant leakage.

If any leakage is found, replace the engine water pump assembly.


b.

Turn the pulley and check that the water pump bearing moves smoothly and does not make a noise.

If necessary, replace the engine water pump assembly.


Hide 4.INSPECT FLUID COUPLING ASSEMBLY

a.
A112113

Remove the 4 nuts and fan.


b.
A097646

Check the fluid coupling for damage or silicon oil leaks.

If necessary, replace the fluid coupling assembly.


c.

Install the fan with the 4 nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)