Home › Engine / Hybrid System › 2TR-FE COOLING › WATER PUMP
RM1880E _51 Engine / Hybrid System _013214 2TR-FE COOLING _0068492 WATER PUMP A

2TR-FE COOLING  WATER PUMP  REMOVAL  


PROCEDURE

Hide 3.DISCONNECT RADIATOR HOSE OUTLET

Hide 4.REMOVE FAN SHROUD

A099963

a.

Disconnect the reservoir hose from the upper radiator tank.


b.

Loosen the 4 nuts holding the fluid coupling fan.


c.

Remove the fan and generator V belt (See page Engine / Hybrid System>2TR-FE ENGINE MECHANICAL>DRIVE BELT>REMOVAL).


d.

Remove the 2 bolts holding the fan shroud.


e.

Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

NOTICE:

Be careful not to damage the radiator core.



f.

Remove the fan pulley from the engine water pump.


Hide 6.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

a.

Remove the engine oil level dipstick.


b.

Remove the bolt, engine oil level dipstick guide and O-ring.

HINT:

Cover the guide hole to prevent foreign matter from entering it.



Hide 7.REMOVE NO. 1 IDLER PULLEY SUB-ASSEMBLY

A099635

a.

Remove the bolt, pulley and spacer.


Hide 8.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

A099636

a.

Remove the 3 bolts and belt tensioner.


Hide 9.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A099639

Remove the 10 bolts, engine water pump assembly and gasket.