Home › Engine / Hybrid System › 2TR-FE LUBRICATION › OIL AND OIL FILTER
RM1880E _51 Engine / Hybrid System _013215 2TR-FE LUBRICATION _0068497 OIL AND OIL FILTER A

2TR-FE LUBRICATION  OIL AND OIL FILTER  REPLACEMENT  


CAUTION / NOTICE / HINT

CAUTION:
·

Prolonged and repeated contact with engine oil will result in the loss of natural oil from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.

·

Wear protective clothing and gloves. Avoid contact with used oil. If contact occurs, wash the area thoroughly with soap and waterless hand cleaner. Never use gasoline, thinners, or solvents to wash the skin.

·

In order to protect the environment, dispose of used oil and used oil filters at designated disposal sites only.



PROCEDURE

Hide 1.DRAIN ENGINE OIL

a.

Remove the oil filler cap.


b.

Remove the oil drain plug and gasket, and drain the oil into a container.


Hide 2.REMOVE OIL FILTER SUB-ASSEMBLY

a.
G038461
2.063,0.99 2.688,1.26 true 2.729,1.188 3.156,1.438 0.427,0.25 10 false SST

Using SST, remove the oil filter.

SST
09228-07501  


Hide 3.INSTALL OIL FILTER SUB-ASSEMBLY

a.

Check and clean the oil filter installation surface.


b.

Apply clean engine oil to the gasket of a new oil filter.


c.
G102155
2.917,0.875 2.729,0.813 true 2.948,0.802 3.385,1.063 0.438,0.26 10 false SST
V100135

3/4 Turn


Lightly screw the oil filter into place by hand. Tighten it until the gasket contacts the seat.


d.

Using SST, tighten the oil filter.

SST
09228-07501  

i.

Depending on the work space available, choose from the following.

If enough space is available, use a torque wrench to tighten the oil filter.

Torque:
17 N*m (175 kgf*cm, 13 ft.*lbf)

If enough space is not available to use a torque wrench, tighten the oil filter a 3/4 turn by hand or use a common wrench.



Hide 4.ADD ENGINE OIL

a.

Clean and install the oil drain plug and a new gasket.

Torque:
38 N*m (382 kgf*cm, 28 ft.*lbf)


b.

Add fresh engine oil.

Standard Oil Grade:
Oil Grade Oil Viscosity (SAE)
API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil 5W-30
10W-30
(5W-30 is the best choice for good fuel economy and good starting in cold weather)
API grade SL, SM or SN multigrade engine oil 15W-40
20W-50


Standard Capacity:
Item Capacity
Drain and refill without oil filter change 5.3 liters (5.6 US qts, 4.7 Imp. qts)
Drain and refill with oil filter change 5.6 liters (5.9 US qts, 4.9 Imp. qts)
Dry fill 6.3 liters (6.7 US qts, 5.5 Imp. qts)



c.

Install the oil filler cap.


Hide 5.INSPECT FOR OIL LEAK

a.

Start the engine. Make sure that there are no oil leaks from the areas that were worked on.