Home › Engine / Hybrid System › 2TR-FE LUBRICATION › LUBRICATION SYSTEM
RM1880E _51 Engine / Hybrid System _013215 2TR-FE LUBRICATION _0068496 LUBRICATION SYSTEM G

2TR-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

a.

Warm up the engine, stop the engine and wait 5 minutes.


b.

Check that the oil level is between the dipstick low level mark and full level mark.

If the level is low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill engine oil above the full level mark.



Hide 2.INSPECT ENGINE OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloration or thinning. If the quality is visibly poor, replace the oil and filter (See page Engine / Hybrid System>2TR-FE LUBRICATION>OIL AND OIL FILTER>REPLACEMENT).


Hide 3.CHECK OIL PRESSURE

a.

Remove the engine oil pressure switch assembly (See page Engine / Hybrid System>2TR-FE LUBRICATION>OIL PRESSURE SWITCH>REMOVAL).


b.
A222343
0.427,1.198 0.531,1.198 0.531,1.198 0.76,0.531 true 0.24,1.104 0.771,1.646 0.531,0.542 10 false *1
*1 Oil Pressure Gauge


Install an oil pressure gauge.


c.

Warm up the engine.


d.

Measure the oil pressure.

Standard Oil Pressure:
Condition Specified Condition
Idle 29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
3000 rpm 160 to 490 kPa (1.6 to 5.0 kgf/cm2, 23 to 71 psi)


If the oil pressure is not as specified, check the oil pump (See page Engine / Hybrid System>2TR-FE LUBRICATION>OIL PUMP>INSPECTION).


e.

Remove the oil pressure gauge.


f.

Install the engine oil pressure switch assembly (See page Engine / Hybrid System>2TR-FE LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION).