Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER › 2011.07–2013.08
RM1880E _51 Engine / Hybrid System _013216 2TR-FE STARTING _0068502 STARTER A

2TR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 3.REMOVE FRONT FENDER SEAL

a.

Remove the 5 clips and seal.


Hide 4.REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)

Hide 5.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 6.REMOVE STARTER ASSEMBLY

a.
A253767

Disconnect the starter connector.


b.

Disconnect the terminal cap.


c.

Remove the nut and disconnect the starter wire.


d.
A306427

for Automatic Transmission:

i.

Remove the 2 bolts and starter.



e.
A306428

for Manual Transmission:

i.

Remove the bolt and disconnect the clutch flexible hose bracket.


ii.

Remove the bolt and starter.