Home › Drivetrain › A343E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE
RM1880E _52 Drivetrain _013217 A343E AUTOMATIC TRANSMISSION / TRANSAXLE _0068512 TRANSMISSION CONTROL CABLE A

A343E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Insert the transmission control cable from outside the vehicle and attach the 3 claws of the cable retainer.


b.

Install the 2 nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


c.

Connect the transmission control cable to the shift lever retainer and install a new clip.


d.
C248293
2.802,0.188 2.656,0.188 2.656,0.188 2.448,0.615 true 2.854,0.094 3.104,0.281 0.25,0.188 10 false *1
*1 Ridge


Connect the control cable end to the shift lever.

NOTICE:

Make sure to connect the cable end so that the inner cable is not twisted. Confirm that the ridged side of the cable end is facing upward.



e.

Move the shift lever to N.


f.

Connect the transmission control cable support to the body with the nut.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


g.
C236140
1.365,0.094 1.521,0.271 0.156,0.177 10 N 1.75,0.417 1.906,0.594 0.156,0.177 10 R 2.271,0.313 2.427,0.49 0.156,0.177 10 P

Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.


h.

Connect the transmission control cable to the transmission control cable bracket with a new clip, and then connect the cable end to the control shaft lever with the nut.

Torque:
14 N*m (143 kgf*cm, 10 ft.*lbf)