Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER
RM1880E _52 Drivetrain _013218 CLUTCH _0068520 CLUTCH MASTER CYLINDER A

CLUTCH  CLUTCH MASTER CYLINDER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL MASTER CYLINDER PUSH ROD CLEVIS

a.

Install the lock nut and master cylinder push rod clevis to the push rod.

HINT:

Tighten the lock nut to the specified torque when adjusting the clutch pedal.



Hide 2.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.

Install a new gasket and the clutch master cylinder assembly with the 2 nuts.

Torque:
14 N*m (145 kgf*cm, 10 ft.*lbf)


Hide 3.CONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

Hide 4.CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.
C190847

Using a union nut wrench, connect the clutch master cylinder to flexible hose tube.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 5.CONNECT CLUTCH RESERVOIR HOSE

a.

Connect the clutch reservoir hose to the clutch master cylinder assembly with the clip.

NOTICE:

Connect the clutch reservoir hose so that it is not twisted.



Hide 6.INSTALL COMBINATION METER ASSEMBLY

Hide 7.BLEED AIR FROM CLUTCH PIPE LINE

Hide 8.CHECK FOR CLUTCH FLUID LEAKAGE

HINT:

Check for leaks in the clutch system.


Hide 9.INSPECT AND ADJUST CLUTCH PEDAL ASSEMBLY