Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER
RM1880E _52 Drivetrain _013218 CLUTCH _0068520 CLUTCH MASTER CYLINDER A

CLUTCH  CLUTCH MASTER CYLINDER  REMOVAL  


PROCEDURE

Hide 1.DRAIN CLUTCH FLUID

NOTICE:

Wash off clutch fluid immediately if it comes into contact with a painted surface.


Hide 2.REMOVE COMBINATION METER ASSEMBLY

Hide 3.DISCONNECT CLUTCH RESERVOIR HOSE

a.
C102426

Loosen the clip and disconnect the clutch reservoir hose from the clutch master cylinder assembly.

HINT:

Use a container to collect the fluid.



Hide 4.DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.

Using a union nut wrench, disconnect the clutch master cylinder to flexible hose tube.

HINT:

Use a container to collect the fluid.



Hide 5.DISCONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

Hide 6.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY

a.
C240310

Remove the 2 nuts, clutch master cylinder assembly and gasket.


Hide 7.REMOVE MASTER CYLINDER PUSH ROD CLEVIS

a.

Loosen the lock nut, and then remove the master cylinder push rod clevis and lock nut from the push rod.

NOTICE:

When loosening the lock nut, be sure to hold the clevis in place by its square portion.