1.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
2.REMOVE MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL
Using SST, tap out the manual transmission extension housing oil seal.
Do not damage the installation surfaces of the manual transmission case.
3.INSTALL MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL
Coat the lip of a new oil seal with MP grease.
Using SST and a hammer, tap in the manual transmission extension housing oil seal.
-0.5 to 0.5 mm (-0.0196 to 0.0196 in.)
Be careful not to damage the lip of the oil seal.
4.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY