Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.REMOVE BRAKE DRUM
3.REMOVE REAR SPEED SENSOR LH
4.DISCONNECT BRAKE LINE
Using a union nut wrench, disconnect the brake line from the wheel cylinder.
5.REMOVE REAR AXLE SHAFT ASSEMBLY
Remove the 4 nuts.
Using SST, tap out the axle shaft.
Remove the retainer side gasket.
Disconnect the rear brake and remove the axle housing side.
6.REMOVE REAR AXLE SHAFT OIL SEAL LH
Using SST, tap out the oil seal.